Web ID: W000019220
Mfr. Part: APS1250
- APS1250 serves as an automotive or stationary DC-to-AC inverter with automatic line-to-battery transfer and integrated battery charger.\r
- Supports 120V AC output from a 120V AC line power source or 12V DC battery source.\r
- 16.6 millisecond automatic transfer between line and battery power supports UPS protection during blackouts and voltage fluctuations for equipment compatible with a one cycle transfer time.\r
- 1250 watts continuous AC output in inverter mode, 1440 watts continuous AC output in AC mode.\r
- Double Boost inverter output supports momentary startup loads up to 200% of the continuous rating for up to 10 seconds.\r
- OverPower inverter output supports longer duration overloads to 150% for 1-60 minutes under ideal battery and temperature conditions (For best results, utilize OverPower usage for as short of a duration as possible, ensure battery bank and cabling is able to provide full nominal DC voltage under load and allow inverter/charger to fully cool before and after OverPower usage).\r
- 3 stage, 30 amp battery charger with adjustable settings for wet/gel battery types offers fast, reliable battery recharging.\r
- Protected hardwire bolt-down input lugs safely accept heavy gauge input wiring from attached battery bank.\r
- Two built-in NEMA 5-15R output receptacles pass 120V line power or inverter output through to connected equipment.\r
- Reliability enhanced large-transformer design with secure mounting flanges and protected DC wiring terminals.\r
- Moisture-resistant construction enables vehicular or marine operation in high humidity environments.\r
- 3 position operating mode switch supports "AUTO" mode to enable automatic transfer between DC and AC modes, CHARGE-ONLY to maintain a full battery charge when AC is present without auto transfer and SYSTEM OFF settings.\r
- Set of six front panel LEDs display AC/DC operational modes, overload status, DC voltage level, shutdown status and system fault status.\r
- Set of 4 config
** Unless defective, this product is final
sale once the packaging has been opened.